Kamis, 26 Mei 2011

How to Install Harley Fog Lights

How to Install Harley Fog Lights

How to Install Harley Fog Lightsthumbnail
Adding fog lights will help people see you in low-visibility weather.

Some stock motorcycles do not come with fog lights, but adding them is pretty simple and relatively inexpensive. When picking out the set of lights you want, take into consideration how much power they need to operate and if your Harley can support them. By adding fog lights to your Harley, you can increase the safety of your bike. The lights will help you see in the fog, and help others see you. The lights can also enhance the look of your bike.

Difficulty:
Moderate

Instructions

Things You'll Need

  • Auxiliary lamp kit (kit number 69289-05)
    • 1

      Remove the seat.

    • 2

      Disconnect battery cables, negative first.

    • 3

      Remove the headlight.

    • 4

      Remove the four screws from the headlamp nacelle covers.

    • 5

      Install the double-ended studs, from the kit, into the upper and lower fork brackets.

    • 6

      Install the grooved bushings over the studs.

    • 7

      Install the mounting bracket onto the studs. Slide the slots at the top of the brackets onto the top studs, then rotate the bottom of the mounting bracket until the slots at the bottom of the bracket engage the lower studs.

    • 8

      Secure the mounting bracket using the acorn keps nuts from the kit. Tighten the acorn keps nuts.

    • 9

      Cut the conduit supplied in the kit into two equal-length pieces. Slide a section of the conduit over the wires of each lamp.

    • 10

      Slide a swivel block over the end passing/fog lamp wires.

    • 11

      Slide a belleville washer over the end of the passing/fog lamp wires, with the concave side of the washer facing the passing/fog lamp.

    • 12

      Install the lamp with swivel block and washer assembly on the mounting bracket, by routing the passing/fog lamp wires through the hole in the mounting bracket.

    • 13

      Slide a clamp block and acorn nut over the end of the passing/fog lamp wires, and install the acorn nut on the passing/fog lamp. Hand tighten the acorn nut at this time.

    • 14

      Locate the outer trim ring, inner nesting ring, screw and nut.

    • 15

      Place the inner nesting ring on the bulb. Connect the black wire to the bulb spade terminal next to the bulb indexing tab on the bulb. Install the gray wire on the remaining spade terminal.

    • 16

      Attach the bulb and nesting ring using the trim ring, screw and nut.

    • 17

      Repeat steps 10-16 to install the other side.

Tidak ada komentar:

Posting Komentar